Skip to main content

You're viewing the latest revision of this guide.

Older Newer
  1. The DSE requires four M3 mounting holes, 31mm apart form each other. If your printers gantry is a piece of 2020 aluminium extrusion you may be able to use the Proforge 2S tool carriage, available for separate purchase here.
    • The DSE requires four M3 mounting holes, 31mm apart form each other.

    • If your printers gantry is a piece of 2020 aluminium extrusion you may be able to use the Proforge 2S tool carriage, available for separate purchase here.

  2. Roller Assembly x4: Create a roller assembly by pressing two 625zz bearings into a delrin roller wheel with a 1mm shim between them.
    • Roller Assembly x4:

    • Create a roller assembly by pressing two 625zz bearings into a delrin roller wheel with a 1mm shim between them.

    • Delrin Roller Wheel

    • 625zz Bearing

    • Precision Shim

    • You may need to use a pair of pliers to force the bearings into the delrin wheel.

  3. Assemble the tool carriage rollers as shown in the images: 4x M5 x 25mm bolts 2x M5 spacers
    • Assemble the tool carriage rollers as shown in the images:

    • 4x M5 x 25mm bolts

    • 2x M5 spacers

    • 2x Eccentric spacers

    • 4x M5 washers

    • x4 Roller assemblies

    • x2 M5 Nylocs - Tighten Firmly

    • x2 M5 Nylocs - Tighten Loosely (eccentric spacer should still be able to turn)

    • See Stage 6 of the Proforge 2S build manual for instructions on installing the tool carriage to your gantry.

Makertech 3D

Member since: 03/09/2018

43,445 Reputation

110 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 181