-
-
Complete this stage:
-
If you are upgrading from an already built Proforge 2/2S Single Extruder setup.
-
Skip this stage and continue here:
-
If you are building the Dual Switching Extruder from the Proforge 2/2S build guides
-
-
-
Remove the PTFE Tubing from the Hotend and Extruder.
-
Cut the cable tie holding the cables to the carriage and remove the two M3 x 8mm bolts.
-
-
-
Remove from the Hotend from the mount.
-
Remove the fans from the mount.
-
Remove the probe from the mount.
-
-
-
Remove all of the cable ties from the main branch of cables going down to the base.
-
Cancel: I did not complete this guide.
8 other people completed this guide.