-
-
Follow the guide here for flashing the firmware to the various control boards on the printer.
-
The steps for setting up the ProForge 300 and the ProForge 4.2 are identical, except for the following:
-
In step 5, in the system.cfg file set the hostname to Proforge4. You can then use proforge4.local to reach your printer in the web browser.
-
In step 6, in the armbianEnv.txt file set display overlay to "dsi" if you have the display connected with just one white ribbon cable. Set to "hdmi" If your display is connected via HDMI.
-
In step 11, the config files for the ProFroge 4.2 can be found here.
-
When you reach step 15 see the next step here for the configuration of the Octopus Control Board firmware.
-
-
-
When configuring the firmware for the control board match the settings here for the Octopus Control Board.
-
