Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #10

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

-[title] Probe and Fans
-[* green] Connect the HotEnd Heatsink Fan directly to the power supply.
- [* icon_note] Red = +
- [* icon_note] Black = -
-[* blue] Connect the Print Cooling Fan to the board.
-[* orange] Connect the probe to the board (z-)
+[title] Fans
+[* green] Wind the exposed parts of the HotEnd Heatsink Fan wires and Probe wires together as shown.
+ [* icon_note] Negative: Black (Fan) & Blue (Probe)
+ [* icon_note] Positive: Red (Fan) & Brown (Probe)
+ [* red] Connect the cables that you just wound together directly to the power supply as shown in the second image.
+[* blue] Connect the reming two black and red wires from the probe to the Z- postion on the board.
+ [* icon_caution] Make sure the red wire is going to S (signal) and the black wire is going to G (ground). The pins are marked between the connectors on the board.
+[* orange] Connect the Print Cooling Fan to the Board.

Image 3

Deleted