Changes to Step #26
Step Lines
| [title] Stepper Drivers - Proforge 2S | |
| - | [* green] Prepare |
| + | [* green] Prepare the two TMC2100 stepper drivers by removing them from their packaging and sticking on the Heatsinks as shown in the images. |
| [* icon_note] Make sure the heatsink is not touching any of the pins. | |
| [* icon_note] Orient the fins of the heatsink as shown. | |
| - | [* icon_note] The Kit will have 5 A4988 Stepper dirvers in total, for the Proforge 2S you will only need to use two, the remaining are spares. |
| - | [* blue] Fix the two A4988 Stepper Drivers onto the the control board as shown in the Z and E0 positions. |
| [* orange] Fix the two TMC2100 Stepper Drivers to the X & Y Positions. | |
| - | [* icon_caution] MAKE SURE TO MATCH THE ORIENTATION AS SHOWN IN THE THIRD IMAGE. |
| + | [* icon_caution] When in stalling match the orientation of the drivers as shown in the second image. |
| + | [* icon_reminder] If your building the Proforge 2 use the red A4988 drivers here. |
Image 1
Old Version
New Version
Image 2
Old Version
New Version
Image 3
Deleted