Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #32

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Print Surface Sticker
-[* icon_caution] Before starting make sure the Metal Surface is ***clean***. If possible wipe down with an alchol rub to be certain.
-[* orange] Partially remove the backing paper from the short side of the Print Surface Sticker.
-[* green] Align with the right edge of the Metal Surface on the Proforge 2/2S.
- [* green] Keep an equal distance from all of the edges.
-[* red] Pull back the backing paper and apply pressure to the surface sticker to get it to stick down evenly.
- [* icon_note] Avoid air bubbles.
+[* icon_caution] Before starting make sure the Metal Surface is ***clean***.
+[* icon_note] Partially remove the backing paper from the short side of the Print Surface Sticker.
+[* icon_note] Align the sticker with either the left or right side and evenly apply pressure as you fix the sticker onto the platform.
+[* icon_note] Aim to apply centrally on the platform, keeping an equal gap from all of the edges.

Image 1

No previous image

Added