Makertech
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #13

Edit by Makertech —

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Probe and Fan Cont.
-[* black] Connect the reming two black and red wires from the probe to the Z- postion on the board.
-[* black] Make sure the red wire is going to S (signal) and the black wire is going to G (ground). The pins are marked between the connectors on the board.
-[* black] Connect the Print Cooling Fan to the Board.
+[* blue] Connect the Print Cooling Fan to the board as shown.
+[* red] Connect the remaing two black and red wires from the probe to the Z- postion on the board.
+ [* icon_caution] Make sure the red wire is going to S (signal) and the black wire is going to G (ground). The pins are marked between the connectors on the board.

Image 1

No previous image

Added