Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #13

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

-[title] Probe and Fan Cont.
+[title] Probe and Fans Cont.
[* blue] Connect the Print Cooling Fan to the board as shown.
[* red] Connect the remaing two black and red wires from the probe to the Z- postion on the board.
[* icon_caution] Make sure the red wire is going to S (signal) and the black wire is going to G (ground). The pins are marked between the connectors on the board.

Image 2

No previous image

Added

Image 3

No previous image

Added