Makertech
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #13

Edit by Makertech —

Edit approved by Makertech

Before
After
Unchanged

Step Lines

-[title] Probe and Fans Cont.
-[* blue] Connect the Print Cooling Fan to the board as shown.
-[* red] Connect the remaing two black and red wires from the probe to the Z- postion on the board.
- [* icon_caution] Make sure the red wire is going to S (signal) and the black wire is going to G (ground). The pins are marked between the connectors on the board.
+[title] Print Fan Wiring
+[* blue] Connect both cables form the print fans to the print fan adapter.
+ [* icon_caution] Black to Black and Red to Red
+[* red] Connect the other side of the adapter to the electronics board.

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Deleted