Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #12

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

+[title] Z - Homing
+[* icon_note] To check that the probe and bed is set up correctly we are going to Home all of the axes together.
+[* green] Use your controller to home all of the axes.
+ [* blue] X & Y will automatically home first. Then the probe should move to the centre of the platform and slowly lower until it's triggered.
+ [* icon_reminder] The gantry will go up at first and then begin lowering - this is normal.
+ [* icon_caution] Have your finger ready on the power switch to power off in the event of a crash. If you do crash the hotend into the platform re-check your probe postioning - it's likely too far above the nozzle and needs lowering.

Image 1

No previous image

Added