Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #14

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

+[title] Z-Offset
+[* green] Take the folded piece of paper and place it between the surface and the nozzle of Hotend #1.
+[* red] On your controller lower the nozzle (z-axis) in 0.1mm increments until it ***begins ***to grip the paper.
+[* yellow] Make a note of the Z height when the paper begins to be gripped. (This value will be 3.00mm to begin with, this is normal.)
+ [* icon_reminder] In our case on the Proforge 2S it ended up being ***1.90mm ***when the paper began to be gripped, but this value will be different for everyone.

Image 1

No previous image

Added

Image 2

No previous image

Added