Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Heating Hotends
[* icon_caution] Before powering up either Hotend make sure that the black PTFE tubing is pushed all the way down the Hotend, it should go into the Hotend by 6CM. Double check, as running filament through the Hotend with the PTFE tube not all the way down will ruin the Hotend.
[* icon_note] Heat up both Hotends to 200 Degrees C.