Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Z-Offset Cont.
-[* black] Enlarge the Machine Settings window or scroll down the ''Start G-code'' box until you get to the ''; ----Unique to your setup-----'' section
-[* black] Take the Z-offset distance that you made a note off from [guide|41|Stage 08|stepid=504] and subtract it from 3.
- [* black] So in this case the noted distance was 1.9mm, so our offset will be ***3 - 1.9 = ++1.1++***
-[* black] Enter your calculated offset in place of the ''0.0'' like shown in the second image.
+[* green] Enlarge the Machine Settings window or scroll down the ''Start G-code'' box until you get to the ''; ----Unique to your setup-----'' section
+[* light_blue] Take the Z-offset distance that you made a note off from [guide|41|Stage 08|stepid=504] and subtract it from 3.
+ [* icon_reminder] So in this case the noted distance was 1.9mm, so our offset will be ***3 - 1.9 = ++1.1++***
+[* blue] Enter your calculated offset in place of the ''0.0'' like shown in the second image.

Image 1

No previous image

Added

Image 2

No previous image

Added