Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #8

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Z-Offset start Gcode lines:
-[* icon_note] If you are using a different slicer you can simply copy this section of gcode into your start gcode box:
+[* icon_note] If you are using a different slicer you can simply copy these lines of gcode into your start gcode box:
[* black] G28 ;Home
[* black] G29 ;Autolevel Bed
[* black] G1 F8000 X10 Y3 ;Move hotend to bottom left corner
[* black] G1 Z3 ;Move Hotend to assumed Z Home
[* black] G92 Z0.0 ;Set Z-offset in 0.1mm incriments (increase if first layer too high, decrease if too low)
[* black] M82 ;Absolute extrusion mode
[* black] G92 E0 ;Zero Extruder