Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #11

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

+[title] First layer
+[* icon_note] Check the first layer, it should look like the first image, but it's likely that on the first go the nozzle will be either too high or too close to the print surface.
+[* icon_note] For Example:
+ [* light_blue] Too high - the first layer isn't sticking or the model has peeled off.
+ [* orange] Too low - the nozzles is pressing the plastic down too much, or at worst digging into the bed.