Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #12

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

+[title] Adjusting the Z-offset
+[* icon_note] In order to get the nozzle closer to the bed for the first layer to properly stick we'll need to adjust the z-offset value. ***This value will only need to be dialled in once.***
+[* icon_note] As in step 6/7 go back into machine settings and either increase or decrease the Z-offset by 0.1:
+ [* black] First layer too high: Increase Z-offset
+ [* black] First layer too low: Decrease Z-offset
+[* icon_note] Re-slice the model and save again to the SD card.