Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #15

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

+[title] Deciding X Offset Value
+[* orange] Overlapping in X Direction:
+ [* icon_note] Decrease/Negative X-Offset
+[* blue] Gap in X Direction:
+ [* icon_note] Increase/Positive X-Offset
+[* green] In our case the print was fine in the X-Direction, so we left our X-offset as 0.
+[* icon_reminder] For example, if there had been a gap of 0.25mm, our offset would have been ***0.25mm***.
+ [* icon_reminder] An overlap of 0.25mm would have meant an offset of ***-0.25mm.***

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added