Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #16

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

+[title] Deciding Y-Offset Value
+[* orange] Overlapping in Y Direction:
+ [* icon_note] Decrease/Negative X-Offset
+[* blue] Gap in Y Direction:
+ [* icon_note] Increase/Positive X-Offset
+[* green] In our case the print had a gap in the Y Direction, so we set our Y-offset to ***0.7mm.***
+ [* icon_reminder] If there had been an overlap of 0.7mm, our offset would have been ***-0.7mm***.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added