Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #14

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] LCD Screen Cables
[* icon_note] Connect the cables from the LCD screen to the control board like shown.
+[* orange] Make sure that your cables match the orientation shown. EXT1 from the LCD screen should go to EXP1 on the board.
+[* blue] The red cable should also be on the same side for both cables, like shown.
+[* icon_caution] A batch of cables have the connectors reversed, if you find this to be the case you will need to use a craft knife to cut of the direction tab on one side of the connector in order to fit it in the correct way round on the board. Make sure the knife you use to do this is sharp, and cut down, away from the cable itself.

Image 1

Old Version

New Version

Image 2

No previous image

Added

Image 3

No previous image

Added