Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #19

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Probe Alignment
[* icon_note] If you have the Flexplate upgrade make sure it is on the platform before starting.
[* red] Click "motors off" in Pronterface.
-[* black] Lower the gantry by hand so that the nozzle comes close to the print surface. Once close enough the red light on the probe should come on ***before ***the nozzle hits the print surface.
+[* green] Lower the gantry by hand so that the nozzle comes close to the print surface. Once close enough the red light on the probe should come on ***before ***the nozzle hits the print surface.
[* icon_note] Ideally, when the probe is triggered (as soon as its light shines) the tip of the nozzle should be no more than 1mm above the print surface.
[* icon_caution] Nozzle hits the print surface before the red light on the probe comes on:
- [* black] Lower the probes position on the mount and check again.
+ [* icon_note] Lower the probes position on the mount and check again.
[* icon_caution] Red light on probe but nozzle tip is too far away from the print surface:
- [* black] Raise the probes position on the mount and check again.
+ [* icon_note] Raise the probes position on the mount and check again.

Image 2

No previous image

Added

Image 3

No previous image

Added