Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #22

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Z-Offset
-[* black] G28 - home
-[* black] M114 - report position, zero
-[* black] Lower z
-[* black] M114 - report again
-[* black] Multiply by -1
+[* black] Send G28 to home all axes.
+[* black] Send "M420 S0" to turn off the auto-levelling.
+[* black] Send M114 to report the nozzle position, the Z-axis should be at 0
+[* black] Place a folded piece of paper between the nozzle and print surface. Lower the Z axis in 0.1mm increments until the nozzle grips onto the paper.
+[* black] Send M114 again to report the Z-axis position.
+[* black] The amount that you lowered the z axis by is your Z-offset.
[* black] Enter M206 Z(value)
[* black] M500 save to memory