Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #25

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Heating the Hotend
[* black] Before powering up the Hotend make sure that the black PTFE tubing is pushed all the way down the Hotend, it should go into the Hotend by 6CM. Double check, as running filament through the hotend with the PTFE tube not all the way down will ruin the Hotend.
[* blue] Make sure that the 30mm fan is spinning too, this fan should always be one, powering your hotend without this fan will cause damage.
+[* violet] Raise the gantry up by between 60-80mm
[* red] Set the hotend to 200 degrees and press set to begin heating.
[* icon_note] Wait for the hotend to heat.
[* icon_caution] Caution - the Hotend will cause burns if touched while hot!

Image 1

Old Version

New Version