Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #23

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Z-Offset Cont.
-[* black] Place a folded piece of paper between the nozzle and print surface. Lower the Z axis in 0.1mm increments until the nozzle grips onto the paper.
-[* black] Send the M114 command again to report the Z-axis position.
-[* black] The amount that you lowered the z axis by is your Z-offset.
-[* black] Enter M206 Z(value)
-[* black] Send and M500 command to save it to the printers memory.
+[* orange] Place a folded piece of paper between the nozzle and print surface. Lower the Z axis in 0.1mm increments until the nozzle grips onto the paper.
+[* red] Send the M114 command again to report the Z-axis position.
+ [* red] The amount that you lowered the z axis by is your Z-offset.
+ [* icon_note] In this example case M114 reported the new z-position to be -1 when lowered to grip the paper. There for the Z-offset is 1mm.
+[* green] Enter M206 Z(value)
+ [* icon_note] As in this example case the Z-offset was found to be 1, we enter "M206 Z1".
+[* blue] Send an M500 command to save it to the printers memory.

Image 1

No previous image

Added