Makertech
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #10

Edit by Makertech —

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Heater Block Assembly
[* orange] Fix onto both the heater blocks, the heatbreak.
-[* red] and nozzle.
-[* icon_note] Leave a slight gap between the nozzle and heater block when tightening. The nozzle will need to be tightened again when hot.
+[* red] and the nozzle.
+[* icon_note] Make sure that the nozzle is tight against the heatbreak but leave a slight gap between the nozzle and heater block when tightening. The nozzle will need to be tightened again when hot.