Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #13

Edit by Makertech

Edit approved by Makertech

Before
After
Unchanged

Step Lines

[title] Tidying the Cables
[* green] Take the heater assebly cables and route them along the sides of the backplate. Use cable ties to secure them in place like shown.
[* icon_note] Heater, thermistor, 30mm fan cables.
[* orange] Before firmly securing the cable ties, make sure that there is enough slack in the cables to allow the hotend to pivot.
[* blue] Take the probe, blower fan and servo cables and point them upwards.
-[* violet] Finally, use the braided cable sleeving to wrap the cables and route them down to your controller.