Changes to Step #7

Edit by Makertech 3D

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Probe Setting
[* orange] Set z-probe for homing.
[* green] Define nozzle/probe offset.
[* icon_note] {39.5, 32, 0}
+[* icon_note] Probe Pins:
+ [* icon_note] As mentioned before, in the wiring diagram, the probe's black cable needs to be connected to a digital signal pin on your control board. You can set this pin number by entering the following into either your configurtion.h file or directly into your boards pins.h file.
+ [* violet] In lib/src/pins/...your control board
+ [* violet] Here, the Z_MIN_PROBE_PIN is pointing to pin 4.

Image 3

No previous image

Added