Slide the Support Beam Assembly in through the rectangle hole from the underneath of the Base.
The wider 2040 Beam should be pointing upwards.
Secure the support beam assembly to the base by tightening down the four M5 x 8mm bolts.
Use the rectangle holes to check that all of the T-Nuts have correctly attached to the extrusion beams. Sometime you may need to use the end of an allen key to force them to turn.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.