If you are deciding to use the included probe for auto-levelling you will need to wire it like shown:
Brown cable directly to 12/24V power.
Blue cable goes to a ground (GND) pin on your board.
Black cable goes to a digital (D) pin on your board. Make a note of this pin number as we'll be setting this in the firmware later.
On the MKS GEN_L board this is pin D63
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.