To check that the probe and bed is set up correctly we are going to Home all of the axes together.
Use your controller to home all of the axes.
X & Y will automatically home first. Then the probe should move to the centre of the platform and slowly lower until it's triggered.
The gantry will go up at first and then begin lowering - this is normal.
Have your finger ready on the power switch to power off in the event of a crash. If you do crash the hotend into the platform re-check your probe postioning - it's likely too far above the nozzle and needs lowering.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.