Take the folded piece of paper and place it between the surface and the nozzle of Hotend #1.
On your controller lower the nozzle (z-axis) in 0.1mm increments until it begins to grip the paper.
Make a note of the Z height when the paper begins to be gripped. (This value will be 3.00mm to begin with, this is normal.)
In our case on the Proforge 2S it ended up being 1.90mm when the paper began to be gripped, but this value will be different for everyone.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.