This step is the same as the last step from the previous stage.
After homing all of the axes place a folded piece of paper between the print surface and the nozzle of Hotend #1.
Lower the Hotend in 0.1mm increments until the paper begins to be gripped by the nozzle.
Make a note of the Z height displayed on the top right of the touch screen when the paper begins to be gripped. (This value will be 3.00mm to begin with, this is normal.)
In this case it ended up being 1.90mm when the paper began to be gripped, but this value will likely be different for everyone.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.