For the calibration model we suggest using the default settings in CURA.
Extruder: Select the Hotend you would like the changes in the settings to affect.
Material: Makertech PLA+ (the included sample filament)
Nozzle size: Set the nozzle size to match your setup, the default is 0.3mm.
0.2mm Layer Height: A good compromise between speed and quality.
30% infill - 30% of the inside of the part will be plastic.
Build Plate Adhesion - Brim: A single layer around the base of your model to prevent warping.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.