Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

If you are using a different slicer you can simply copy these lines of gcode into your start gcode box:

G28 ;Home

G29 ;Autolevel Bed

G1 F8000 X10 Y3 ;Move hotend to bottom left corner

G1 Z3 ;Move Hotend to assumed Z Home

G92 Z0.0 ;Set Z-offset in 0.1mm incriments (increase if first layer too high, decrease if too low)

M82 ;Absolute extrusion mode

G92 E0 ;Zero Extruder

Your contributions are licensed under the open source Creative Commons license.