In order to get the nozzle closer to the bed for the first layer to properly stick we'll need to adjust the z-offset value. This value will only need to be dialled in once.
As in step 6/7 go back into machine settings and either increase or decrease the Z-offset by 0.1:
First layer too high: Increase Z-offset
First layer too low: Decrease Z-offset
Re-slice the model and save again to the SD card.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.