Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 15 —

Step Type:

Drag to rearrange

Overlapping in X Direction:

Decrease/Negative X-Offset

Gap in X Direction:

Increase/Positive X-Offset

In our case the print was fine in the X-Direction, so we left our X-offset as 0.

For example, if there had been a gap of 0.25mm, our offset would have been 0.25mm.

An overlap of 0.25mm would have meant an offset of -0.25mm.

Your contributions are licensed under the open source Creative Commons license.