Connect the cables from the LCD screen to the control board like shown.
Make sure that your cables match the orientation shown. EXT1 from the LCD screen should go to EXP1 on the board.
The red cable should also be on the same side for both cables, like shown.
A batch of cables have the connectors reversed, if you find this to be the case you will need to use a craft knife to cut of the direction tab on one side of the connector in order to fit it in the correct way round on the board. Make sure the knife you use to do this is sharp, and cut down, away from the cable itself.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.