Put the Axis onto its back for easier access to the other side of the belt.
Pull the belt around the bolt, do so tightly and use a bulldog clip to hold in place temporarily. Or ask some one to hold the belt together with a pair of pliers.
Make sure that the belt is still correctly weaved through the bearing idlers.
Whilst under tension, use cable ties to firmly secure the belt in place.
Cut off any excess, leaving about an inch.
We recommend that the belt be "guitar string tight". Too tight or too loose and print quality will be affected. If in doubt, tighter is usually better, but if you start warping the metal then you've gone too far.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.