Click in the following order, allow each command to complete before moving to the next:
Home X - The platform will move all the way to the left until the end-stop on the base is triggered.
Home Y - The hotend will move towards the z-pillar until the eccentric guide triggers the end-stop on the gantry.
Lower the Z axis - Lower the gantry incrementally to check the that the nozzle is aligned with the top right corner of the print surface, this is your (300,200) co-ordinate.
The hotend nozzle should be above the top right corner of the print surface.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.