Place a folded piece of paper between the nozzle and print surface. Lower the Z axis in 0.1mm increments until the nozzle grips onto the paper.
Send the M114 command again to report the Z-axis position.
The amount that you lowered the z axis by is your Z-offset.
In this example case M114 reported the new z-position to be -1 when lowered to grip the paper. There for the Z-offset is 1mm.
Enter M206 Z(value)
As in this example case the Z-offset was found to be 1, we enter "M206 Z1".
Send an M500 command to save it to the printers memory.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.