Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 10 —

Step Type:

Drag to rearrange

Heat the hotend up to it's max temps. That's 250C for the low temp configurations and 400C for the high temp configuration.

When up to temperature tighten the nozzles against the heatbreak.

Make sure that the two bolts on the side of the heatsink are also tightened and are holding the heatbreak securely.

Take caution when doing this step as the hotend will be hot enough to cause severe burns. Use two pliers, one to hold the heater block and the other to tighten the nozzle.

Your contributions are licensed under the open source Creative Commons license.