Skip to main content
/

Site Navigation

Your Account

Choose Language

Help
Editing Step 9 —

Step Type:

Drag to rearrange

Loop the lengths of belt around, making sure to keep them from getting twisted. The inside of the loop should be the toothed side of the belt. Feed the other end into the corresponding slot on the other side of the tool carriage.

Use the remaining belt clamp to hold the belt in place.

M3 x 6mm Cap

Do not tighten this clamp down fully, but just enough to hold the belt in place. You should still be able to pull and push the belt through the slot.

Leave a couple inches free.

Your contributions are licensed under the open source Creative Commons license.