Use a pair of needle nozzle pliers (included) to tighten the belts.
Grip the belts with the pliers and twist against the carriage to tighten.
Before starting, make sure that the clamp is tightened down enough to allow you to pull more belt through, but not allow the belt to slip back.
As a rule of thumb, the belts should be guitar string tight. However, if in doubt, tighter is better.
Trim away excess belt leaving approx an inch.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.