Help
Andrew LeRoy
@aleroy
Andrew LeRoy
| 4 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 08/09/2020 | |
| 4 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 08/09/2020 | |
The thermistor has the wrong connector as well. It should be a JST (as shown in the wiring stage) rather than the female jumper connector (as shown above). Albeit, since I have a stash of JSTs and had to splice the extra 20 cm anyways … well, it wasn’t all that big a deal.
Wait. Where’s the step for installing the PTFE tubing?
Touchscreen?
OSX Catalina users:
You’ll either need to build pronterface yourself or you can use the binary linked in this thread (from their github issues):
https://github.com/kliment/Printrun/issu...
The one listed in their downloads is a 32bit binary (Catalina no longer supports 32bit apps).
Point the marking inward when you insert the platform.
Never mind. That’s what the eccentric guides are for. Sorry.
Okay…it becomes apparent when inserting the platform. Keeping these slightly loose will make it easier to slide to the platform into place. Then I tightened them making sure the platform could slide easily.
How well aligned do these need to be? Might have been easier to square these up without the uprights and motors attached.