One of the power supply has stopped working correctly (I have tried inverting them and in effect one goes bad) can you tell me the power and the model or where to get the same?
The hot bed was not starting correctly and I have had a hard time locating the error.
Testing I think it is due to the 1cm cut PTFE tubes that go inside the nut. The filament collides with them inside the splitter. Even sharpening the filament it does not enter easily, and it gets stuck, to activate the double extrusion that will be a problem.
I have the feeling that the splitter makes the passage of the filament difficult, is there any way that this does not happen or is it easier? Maybe I have something wrong
What do you mean when you say that he grabs the paper? When does resistance or when it prevents to remove the paper?
And another question:
If the final result is between 0.1 and 0.9, should the command be sent with decimals?
One of the power supply has stopped working correctly (I have tried inverting them and in effect one goes bad) can you tell me the power and the model or where to get the same?
The hot bed was not starting correctly and I have had a hard time locating the error.
Testing I think it is due to the 1cm cut PTFE tubes that go inside the nut. The filament collides with them inside the splitter. Even sharpening the filament it does not enter easily, and it gets stuck, to activate the double extrusion that will be a problem.
I have the feeling that the splitter makes the passage of the filament difficult, is there any way that this does not happen or is it easier? Maybe I have something wrong
If home does not leave z in 0? I lower it to 0?
How far should the double extruder filament go? Which of the two filaments should reach the hotend?