Cristian Iaciu

If you are doing the leveling via this method, be sure to add into calculation the thickness of the sticker on top of your flex plate! The probe is not detecting that! I flipped over my flex plate and will remove the sticker in the near future. This removes any extra mm to the Z offset and provides a smooth surface to print on!

I would not install this sticker because it is thick and the leveling probe is not going to detect it. The probe will always detect the flex plate underneath this sticker. If you are leveling via the probe, be sure to add the thickness of this sticker into consideration! I flipped over my flex plate and I am now printing on a smooth surface and with the probe detecting correctly the distance.

I would not install this sticker because it is thick and the leveling probe is not going to detect it. The probe will always detect the flex plate underneath this sticker. If you are leveling via the probe, be sure to add the thickness of this sticker into consideration! I flipped over my flex plate and I am now printing on a smooth surface and with the probe detecting correctly the distance.

I see that with Bed Leveling ON (M420 SO) Z is 2.41 and with Bed leveling OFF (M420 S0) Z is 1.9

Steps I took: Sent G28 -> display and Pronterface says Z is 1.9; Sent M420 S0 -> Bed Leveling OFF and Fade Height OFF; Sent M114 -> Z is still 1.9.

What does this measure? What do I have to adjust by 1.9mm ?

After this step, Z is at 1.9 but the probe and head are aligned as in step 19 with no room to lower Z to 0. Do I reset Z to 0 in this position? How?