MartinBahmann

I wanted to update my post but can’t do because of the 5 minutes limit. So here is the Update

Electronics fan and LEDs work fine.

I heated the nozzle to 60°C but the Hotend cooling fan isn’t spinning at any time (nozzle temp was over 90°C). Connected to an other 24V pin the fan is running. What can i do?

Update was successfull. I had to reverse the two white display cables to get the Display to work.

Because of the identical dimensions in X and Y, more an issue than a Problem: I checked the wiring but my X-axes was moving in the wrong direction (X- was running to the right and X+ to the left). So Homing X would end in a crash at the right side. I change the two motor cables with each other but that converts X in Y and Y in X.

Now i changed the right motor cable to one that have no crossed cables. My X and Y is reversed now so that i had to reverse the limit switches too. But its ok for the moment because both have 300mm length.

Thank You

The Hotend cooling fan is’nt spinning at any time, Electronics fan and LEDs work fine. Update was successfull but after it the display is just blinking (background light). Idownloaded the file again,checkthe filesize onthe image above but all the same. What can i do?

Thank You