when I press ‘on’ it the print head moves but the button on the touch screen doesnt change, it stays as ‘off’.
after calibrating with the sheet of paper I save the setting, which seems to save ok.
but then when I go to the next step, auto leveling, the print head moves around in a square of about 100mm and says ‘bed leveling failed’ at the end of the process.
Does the auto leveling move aroud the whole bed? If so it seems to think that the bed is about 100mm square?
10mm bolts too long again, you need 8mm as the last stage.
yes the 10mm bolts are too long, you need 8mm bolts.
when I press ‘on’ it the print head moves but the button on the touch screen doesnt change, it stays as ‘off’.
after calibrating with the sheet of paper I save the setting, which seems to save ok.
but then when I go to the next step, auto leveling, the print head moves around in a square of about 100mm and says ‘bed leveling failed’ at the end of the process.
Does the auto leveling move aroud the whole bed? If so it seems to think that the bed is about 100mm square?
Anyone got any ideas?
solved, I had left the orange stoppers in the linear rail!
Mine seems to be nowhere near touching the microswitch. What have I done wrong?
Steve, did you solve your problem?