ran it from the touchscreen console - I had to run this in two separate steps (1x calibrate X-axis, automatic reboot; 1x calibrate Y-axis, automatic reboot).
This came apart for me very easily. Already during the first calibration, leaving me very confused why my cam stopped working suddenly. I've added a tie wrap around the two halves to lock them together.
note that the "Z-offset" is not in the same position as in the photo; it's one code block above.
the resonance is also dependent on the surface your printer is standing on. if you move it, you may need to redo this step
Upgrade: Cable Supports
Upgrade: Cable Supports
ran it from the touchscreen console - I had to run this in two separate steps (1x calibrate X-axis, automatic reboot; 1x calibrate Y-axis, automatic reboot).
worked fine despite that.
@makertech3d What are good values to have? what can we adjust to correct the values, if not good?
This came apart for me very easily. Already during the first calibration, leaving me very confused why my cam stopped working suddenly. I've added a tie wrap around the two halves to lock them together.
Snaps very easily
Be careful to check if the coupler might be loose; otherwise you might not see the motion even though it is happening!
You can use some of the braided sleeve from the printheads; you'll have plenty there.
Also, do not tie the zip ties down until after you're done with the enclosure, you'll need to reposition often throughout the build.
Page 1 of 2
Next