Didn´t know where to put this question. We installed a Camera. Where can I see what my camera is currently seeing or videos it has recorded ? Couldn´t find the discription :)
I went trough all steps and the printer successfully printed. But after a week I had the problem that it does connect with wifi but at the IP there is a questionmark. It does not go away after some time and I can´t connect with ".local" or cura anymore. Is there a way to fix it? And can i still import ".gcode" via USB the oldscoolway?:) Is there a way to connect via lan-cable?
It only works when i put an # before the calibrate...cfg file in printer.cfg (did not put in the calibrate...cfg. file because that´s in step 9 and not now if you put it in more Errors wil accure) :)
I'm not sure how the roof and the cables of the four extruders fit together. I'm afraid that the cables won't be able to move so well through the roof?
Didn´t know where to put this question. We installed a Camera. Where can I see what my camera is currently seeing or videos it has recorded ? Couldn´t find the discription :)
I went trough all steps and the printer successfully printed. But after a week I had the problem that it does connect with wifi but at the IP there is a questionmark. It does not go away after some time and I can´t connect with ".local" or cura anymore. Is there a way to fix it? And can i still import ".gcode" via USB the oldscoolway?:) Is there a way to connect via lan-cable?
There is no Communication Interface (USB) only (USBSERIAL). Is it the right one?
Are these Klipper Firmware Configurations the right ones? Because those in Step 8 are different.
It only works when i put an # before the calibrate...cfg file in printer.cfg (did not put in the calibrate...cfg. file because that´s in step 9 and not now if you put it in more Errors wil accure) :)
I'm not sure how the roof and the cables of the four extruders fit together. I'm afraid that the cables won't be able to move so well through the roof?
Still need to do this if I got the Auto Calibration Probe with the Steelball?
Make sure you put the Buildplate back on after the holecutting! :')
Termius Step 15.