I got the Preassembled Printer, all tests so far where successful.
However Bed Leveling always fails.
I am 99% certain that it is because my Print-Bed is really visibly crooked and it seems the bed-leveling only moves the bed a certain amount which is not enough to get to the point the z-endstop triggers for some probe points.
Any idea what i can do to manually get the bed more level by default? The Bed has no spring leveling system like some other printers. Only idea i had so far is adding some washers to one side to get the bed a bit higher on one side.
It was too hard for me to push it through completely, so i ended up and filed a little bit plastik away from the servo housing. I dont think that should harm it.
Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
I got the Preassembled Printer, all tests so far where successful.
However Bed Leveling always fails.
I am 99% certain that it is because my Print-Bed is really visibly crooked and it seems the bed-leveling only moves the bed a certain amount which is not enough to get to the point the z-endstop triggers for some probe points.
Any idea what i can do to manually get the bed more level by default? The Bed has no spring leveling system like some other printers. Only idea i had so far is adding some washers to one side to get the bed a bit higher on one side.
It was too hard for me to push it through completely, so i ended up and filed a little bit plastik away from the servo housing. I dont think that should harm it.